Upute za upotrebu UNIROSS SPRINT 1H

[. . . ] Use of controls or adjustments or performance of procedures other than those speci?ed herein may result in hazardous radiation exposure. Caution Label You have 6 preset modes (FLAT, ROCK, POP, VOCAL, JAZZ, CLUB). You can customize your settings for these and save them for instant recall. SQ3 (3-Band Sound Quality) Center frequency and level are adjustable in each of 3 bands. [. . . ] ignition switch to the ACC or ON Power). The demonstration screen \CQ-RX400N\ \CQ-RX300N\ \SPRINT 1H\ ). [TA/AF] ( ?Radio Data System (RDS) in FM Broadcasting?) AUX IN*: \CQ-RX400N\ \CQ-RX300N\ \SPRINT 1H\ [BAND] selects a band in the radio source. [APM] (Auto Preset Memory) executes APM in the radio source. (Hold it down for more than 2 seconds. ) SQ (Sound Quality) 4 5 For using the remote control, press [0] ( Notes: Press [VOL] (PUSH SEL: Select) to select DEMO. Turn [VOL] counterclockwise. [SRC] (Source) selects a source. [PWR] (Power) toggles power on/off. [DISP] (Display) switches the information on the display. 1 2 3 lights while receiving an FM stereo signal. [DISP] (Display) exits from the audio menu. Press [VOL] (PUSH SEL: Select) to open the audio menu. Press [VOL] (PUSH SEL: Select) to select SQ. Turn [VOL] to select the sound type as follows. [DISP] (Display) exits from the function menu. Preset buttons [1] to [6] selects a preset station in the radio source, and presets the current station. (Hold it down for more than 2 seconds. ) to open the audio 1 PressIf[VOL] (PUSH SEL)for more than 5 seconds menu. setting (2 seconds in the volume adjustment, Note: no operation takes place in audio 10 seconds in the SQ adjustment), the display returns to the regular mode. (PUSH 1 Hold down [VOL]takes place SEL) for 2 sec. or more to open the function menu. the regular mode. Do not activate SQ and Bass/Treble at the same time to avoid causing sound distortion. : LOCAL OFF (Default) : LOCAL ON lights. ) SQ (Sound Quality) (Setting Range: FLAT/ROCK/POP/VOCAL/JAZZ/CLUB, Default: FLAT) ( ?Sound Control?) Radio AM Local [AM] Only stations with good reception are detected in seek tuning. The 24-hour system is used for the clock. Minute blinks ( Right) ( Right) Clock Setting 2 Press [DISP]. (clock display) 6 Adjust the minute. Minute entered [ [ ]: sets the minute ahead. ]: sets the minute back. Note: Select USB Connector mode to operate the iPod series connected with USB connector. ( System Upgrade System-up Connector \CQ-RX400N\ \CQ-RX300N\ \SPRINT 1H\ When an optional device is connected: Shift to connected device When connecting CD changer Guidebook) \SPRINT 1H\ Up to 6 stations can be preset in AM, FM1, FM2, and FM3 respectively. Preset stations can be simply called up by pressing [1] to [6]. (Tone/SQ adjustable range: 12 dB to 12 dB (by 2 dB)) Setting range: SQ Low/Bass: 12 dB (at 60 Hz, 80 Hz, 100 Hz, 200 Hz) SQ Mid: 12 dB (at 500 Hz, 1 kHz, 2 kHz, 3 kHz) SQ High/Treble: 12 dB (at 10 kHz, 12 kHz, 15 kHz, 18 kHz) / [ [ : center frequency up/down ][ ]: Band selection ] [ ]: Level up/down SQ Adjustment Select the radio 1 [LW/MW]/FM)?). ( ?Radio (AM 5 Press [DISP]. General Operations ( System-up Connector AUX 1* USB Connector CT CT SQ Adjustment : LOCAL OFF (Default) : The frequency is changed only for programs within the region. : The frequency is changed also for programs outside the region. (Default) : English (Default) 4 Hold down the numeric button [2] to [6] for 2 sec. or more. Region ]RDS] Note: When the Region mode is switched from OFF to ON or vice versa, the AF mode turns on automatically. When connecting iPod Station Preset 3 Hold down [DISP] for more than 2 seconds. Hour blinks Radio System-up Connector ( Right) Disc Player AUX 1* When connecting Bluetooth Unit Auto Preset Memory (APM) With this operation, stations with good receiving conditions can be automatically stored in the preset memory. Manual Station Preset Balance (Setting Range: 15 levels each, Default: CNT (centre)) : Right enhanced : Left enhanced 7 Press [DISP]. Notes: 4 Adjust the hour. Hour entered [ [ ]: sets the hour ahead. ]: sets the hour back. Completed \CQ-RX103N\ \CQ-RX102N\ \CQ-RX101N\ Radio Disc Player AUX* ? [. . . ] Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection. Observe the following cautions when using USB device. [. . . ]